Basic Starter Press On Kit

Bond Application

Apply a thin, even layer of Bond to the base of your natural lashes from underneath. Focus only on the area where the lash clusters will attach — there is no need to coat the full length of the lash.

Allow the bond to sit for 30–60 seconds until it becomes tacky. This ensures a stronger, longer-lasting hold.

For added hold, a small amount of bond may also be applied to the base of the lash cluster before placement. If doing so, allow the adhesive on both the natural lashes and the cluster to become tacky before applying.

Work in small sections, applying and placing clusters one area at a time for best results.

Sealer Application

Once all lash clusters are applied, gently brush or dab the Sealer onto the base of the lashes, focusing only on the areas where the bond was used.

The sealer helps:

Lock the lashes in place

Eliminate any remaining tackiness

Extend wear time

Allow the sealer to dry completely. Avoid brushing the sealer through the full length of the lash clusters.

Pro Tip (optional, if you want to include)

Use sealer sparingly — applying too much or pulling it through the lashes may cause clusters to stiffen or clump.